How To Unbrick, Fix Hang The Logo Asus Zenfone 3 Laser (ZC551KL)

How to unbrick, fix hang the logo Asus Zenfone 3 Lazer (ZC551KL)

Introduction:

(Asus Zenfone 3)In the world of smartphones, enthusiasts often find themselves exploring custom ROMs and tweaking their devices for a personalized experience. However, this adventurous journey may sometimes lead to unforeseen issues, such as bricking or the infamous hang logo problem. In this guide, we’ll delve into the steps to restore the stock ROM on Huawei Y6 Pro (TIT-AL00) with MT6735 chipset and troubleshoot the hang logo issue on Asus Zenfone 3 Laser (ZC551KL).

Section 1: Restoring Stock ROM on Huawei Y6 Pro (TIT-AL00) (MT6735):

1.1 Overview of Stock ROM: Before we embark on the journey of unbricking, let’s understand the significance of a stock ROM. A stock ROM is the original operating system that comes pre-installed on your device. Restoring it can be crucial to resolve issues caused by custom ROMs or modifications.

1.2 Preparing Your Device: Ensure that your Huawei Y6 Pro (TIT-AL00) is charged sufficiently and back up essential data. Download the official stock ROM for your device from the official Huawei website to avoid compatibility issues.

1.3 Step-by-Step Unbricking Process: Follow these steps to unbrick your Huawei Y6 Pro:

  • Power off your device.
  • Boot into recovery mode by holding the volume up and power buttons simultaneously.
  • Choose the “Wipe Data/Factory Reset” option to clear previous installations.
  • Select “Install from SD Card” and navigate to the downloaded stock ROM file.
  • Confirm the installation and wait for the process to complete.

1.4 Verifying Successful Restoration: Once the installation is complete, your Huawei Y6 Pro should reboot into the stock ROM. Check for system stability and performance to ensure a successful restoration.

Section 2: Fixing Hang Logo Issue on Asus Zenfone 3 Laser (ZC551KL)

2.1 Understanding the Hang Logo Issue: A hang logo is a common problem that Asus Zenfone 3 Laser users may encounter after customizations. This issue often arises due to incompatible or faulty software installations.

2.2 Initial Troubleshooting: Start by rebooting your Asus Zenfone 3 Laser into recovery mode. Wipe the cache partition to eliminate any temporary files causing the hang logo problem. If the issue persists, proceed to the next step.

2.3 Reverting to Stock Firmware: Similar to Huawei Y6 Pro, reverting to the stock firmware is crucial for resolving hang logo issues on the Asus Zenfone 3 Laser. Download the official firmware from the Asus support website and follow the installation instructions provided.

2.4 Performing a Factory Reset: If the hang logo problem persists, perform a factory reset through the recovery mode. This step will erase all data on your device, so ensure you have a backup.

2.5 Seeking Professional Assistance: If all else fails, consider reaching out to Asus customer support or visiting an authorized service center for expert assistance.

Conclusion:

Restoring the stock ROM on the Huawei Y6 Pro and fixing the hang logo issue on the Asus Zenfone 3 Laser are essential tasks that can breathe new life into your devices. By following these step-by-step guides, you can overcome common issues and ensure the optimal performance of your smartphones. Remember to exercise caution and back up your data before proceeding with any modifications to avoid potential data loss.

DOWNLOAD:

Also Visit addROM.org

HOW TO FLASH:

Leave a reply

Your email address will not be published. Required fields are marked *

You may also like