Stock ROM Fixes LCD Screen Error For Masstel Tab 8 Pro
Introduction:
If you’re experiencing an LCD screen error on your Masstel Tab 8 Pro and you want to fix it by flashing the stock ROM, here are general steps to guide you. Please note that these steps might vary slightly based on the specific model and the ROM you’re using, so be sure to check the manufacturer’s website or forums for device-specific instructions.
- Backup your data: Before proceeding, it’s essential to back up your important data to prevent any potential loss during the flashing process.
- Download the Stock ROM: Visit the official Masstel website or reputable forums to find the correct stock ROM for your Masstel Tab8 Pro model. Download the firmware file to your computer.
- Install USB Drivers: Make sure you have the appropriate USB drivers installed on your computer to establish a connection with your Masstel Tab8 Pro.
- Enable USB Debugging: On your Masstel Tab 8 Pro, go to Settings > About phone > Tap on ‘Build number’ multiple times until you see a message saying “You are now a developer!” Go back to Settings > Developer options > Enable USB debugging.
- Charge your device: Ensure your Masstel Tab 8 Pro has sufficient battery charge to avoid any disruptions during the flashing process.
Other Steps to proceed:
- Download Flashing Tool: Depending on the device and manufacturer, you might need a specific flashing tool. Common tools include SP Flash Tool for MediaTek devices or Odin for Samsung devices. Download the appropriate tool for your Masstel Tab8 Pro.
- Extract the Stock ROM: Extract the downloaded stock ROM file to a folder on your computer.
- Launch the Flashing Tool: Open the flashing tool on your computer. The specific steps may vary, so refer to the tool’s documentation for guidance.
- Load the Stock ROM: In the flashing tool, locate and load the stock ROM file you extracted earlier.
- Connect your Masstel Tab 8 Pro: Power off your device. Connect it to your computer using a USB cable while holding down the specified key combination to enter the flashing mode. The combination might involve volume buttons or a dedicated key. Refer to your device’s manual or online resources for the correct combination.
- Start the Flashing Process: Once your device is connected in flashing mode, start the flashing process in the tool. Wait for the process to complete; this may take some time.
- Completion and Reboot: After the flashing process is complete, disconnect your Masstel Tab8 Pro from the computer and reboot it. The first boot may take longer than usual.
Summary:
This process should replace the existing firmware on your Masstel Tab 8 Pro with the stock ROM, potentially resolving the LCD screen error. If you encounter any issues during the process, consult the official Masstel support or community forums for assistance.
Download:
- MT6580__joyar__Tab8Pro__9__K708I_WXGA.P0.V3.163.RC-V10.6014__PPR1.180610.011__PhamGiang.rar (882M) | OneDrive | Backup | Backup2
